JJJ wrote

I have a mill very similar to yours in fact I
believe the only difference is the x axis hand crank on the
right side. Mine does not have the spring as yours does .
As far as the name brand goes I dont know it off hand but it is
from china 9 x 32 table 5 in. Z travel , 500 or 600 lbs., mine is also
2hp 110ac. spindle to. I think 2500rpms or at least thats what it
says
belt driven

the servo system is probably overkill for a mill/drill and about 800
more than I want to spend.

Are you planning on buying everything at once or alittle here and
there

I could probably get away w/ 2axis right now .Do you know if its a
pain to add z axis later .I'm just afraid that I'll get everything for
2 axis
I guess I would get everything except the 3rd motor

You really think the whole kit and kaboodle will be about 1100 or
1200.00 That would be great.

Joe