peter michaux <porkproducts@home.com> wrote

More great info!

I like your zeroing technique. Very simple and easy to use I am sure. Being
able to check the position quickly at every tool change is very appealing to
me.

I also like the idea of the outboard support bearing. I was thinking about
that today. I don't think the motor shaft should do all that work. It should
just do the turning. Did you use ball bearings?

I must say that the people at this news group are the most thorough and most
helpful I have come across. Once I am an "expert" I will try to pass along
the knowledge you all have shared with me.

Thanks,
Peter
(Please email me at porkprod@yahoo.com)