From: peter michaux <porkproducts@yahoo.com>

Hi Charles,

Thanks for taking the time to fill me in on all those questions. I don't
want to impose too much on your time but your last email made me think of a
few more questions. So if you have the time I would appreciate your insight.

<<I used 1 1/2" belts geared 1.5 to 1>>
When you say 1 1/2" belts do you mean belts with the notches on one side so
there is no slipping? (I think car timing belts are like this.) Here is a
picture of what I am thinking of http://sme.asiaep.com/b1.jpg

<<I use an indicator to locate a reference point>>
What sort of indicator? (I have a feeling this is a software indicator that
is a feature of the Ah-ha software.)

<<I then set indicators to the table out where I want to do a part or tool
change.>>
I don't quite follow you on this stuff. I think if I understand the
indicator stuff you were talking about better I will understand what your
are talking about here.

Thanks again,
Peter