|
|
|
|
EDO 2425 Front Right View
Note original aux fin.. must keep in mind when docking and launching from ramps. I've removed this fin during my 2001 rebuild and installed the Univair Finlets instead. This should make docking and turning in strong wind easier.
EDO 2425 Rear View
Rear view showing extended rudder control arms. Always use springs in your water rudder control setup to reduce stress on the lower rudder skins... even so, reinforcement of the lower rudder skins will likely be require, as cracks often develop due to the extra stress induced when taxiing in crosswinds.
EDO 2425 Front Lower View
Front lower view. Note: struts and wires
EDO 2425 Right Side View
Right side view showing strut arrangement. Steps are optional. All strut end fittings should be held in place with 4 large alum rivets, (8/strut) . Fewer rivets or use of AN alum nuts and bolts would indicate repaired or manufactured parts.
|
|
Send mail to flightlines@shaw.ca with
questions or comments about this web site.
|
